Replacement drum for Quest M3 - future modifications - Page 2
- TomC (original poster)
- Team HB
- Posts: 10552
- Joined: 13 years ago
Thank you Bill! My plans were to do exactly that to the drum, with the perforation only in the center. My 1 kilo is the opposite, with the entire back wall perforated. After meeting with Jay Endres (of Coffee-Tec) at a Joper presentation, I decided that I should at least try to mimic the same design, and put it on my 1 kilo.
I'd be thrilled to hear your findings as well. Thanks for sharing.
I'd be thrilled to hear your findings as well. Thanks for sharing.
Join us and support Artisan Roasting Software=https://artisan-scope.org/donate/
- FotonDrv
- Supporter ♡
- Posts: 3748
- Joined: 11 years ago
Bill, thanks for that detailed Post about the Mod.
Did you keep the stock fan?
Did you cut the resistor out of the circuit to give more fan control?
Did you keep the stock fan?
Did you cut the resistor out of the circuit to give more fan control?
That Light at the End of the Tunnel is actually a train
- erics
- Supporter ★
- Posts: 6302
- Joined: 19 years ago
Tom -
I hope that one of the "nudges" between you and Ms. Molly were about the rotation of the replacement drum you wanted.
I hope that one of the "nudges" between you and Ms. Molly were about the rotation of the replacement drum you wanted.
- TomC (original poster)
- Team HB
- Posts: 10552
- Joined: 13 years ago
She made sure to verify which roaster (including a photo of the front) before shipping.
Join us and support Artisan Roasting Software=https://artisan-scope.org/donate/