Artisan setup: Vint TMP1200 2xRTD
- Almico
- Posts: 3612
- Joined: 10 years ago
- CarefreeBuzzBuzz
- Posts: 3880
- Joined: 7 years ago
Wires are backwards. Jumpers go on + side.
https://www.phidgets.com/?prodid=968
Please contribute to Artisan for the support by making a donation.
https://www.phidgets.com/?prodid=968
Please contribute to Artisan for the support by making a donation.
- Almico (original poster)
- Posts: 3612
- Joined: 10 years ago
- Almico (original poster)
- Posts: 3612
- Joined: 10 years ago
I followed these instructions:
https://artisan-scope.org/phidgets/2x-rtd-set/
I forgot how exquisitely frustrating it is setting this up.
https://artisan-scope.org/phidgets/2x-rtd-set/
I forgot how exquisitely frustrating it is setting this up.
-
- Posts: 3837
- Joined: 10 years ago
I feel sorry for you....I bought the Phidget RTDs and setting up was a blast, selecting the right 'machine' and it was done. (I dreaded the manual setup to be honest)
LMWDP #483
- Almico (original poster)
- Posts: 3612
- Joined: 10 years ago
I selected machine > phidget > 2XRTD. Nada.
I tried every possible wiring configuration of the RTDs, Nada.
The phidget control panel is seeing the TMP 1200s.
I just left it alone. Mondays another day.
I set up the entire roastery and San Franciscan SF 75. Ran all the gas lines. Did all the ductwork. Installed the old roaster. I saved hooking up artisan for last, because I knew it was going to suck.
I tried every possible wiring configuration of the RTDs, Nada.
The phidget control panel is seeing the TMP 1200s.
I just left it alone. Mondays another day.
I set up the entire roastery and San Franciscan SF 75. Ran all the gas lines. Did all the ductwork. Installed the old roaster. I saved hooking up artisan for last, because I knew it was going to suck.
-
- Posts: 1823
- Joined: 17 years ago
Does it matter that your meter choice says it's for 1 RTD?
Edit: Oh dear, sorry, I guess you say you tried that and it didn't help.
Edit: Oh dear, sorry, I guess you say you tried that and it didn't help.
- CarefreeBuzzBuzz
- Posts: 3880
- Joined: 7 years ago
Alan really??? You could pay for Cropster and get full support................
- Almico (original poster)
- Posts: 3612
- Joined: 10 years ago
Certainly an option. There are a few more options out there too. But I've become used to Artisan and have made it work for me.CarefreeBuzzBuzz wrote:Alan really??? You could pay for Cropster and get full support................
SJM wrote:Does it matter that your meter choice says it's for 1 RTD?
Edit: Oh dear, sorry, I guess you say you tried that and it didn't help.
Config>Device>Meter dropdown does not have an option for 2xRTD.
I have the 1XRTD selected from my other roasters saved settings. There doesn't seem to be an obvious other option
- Almico (original poster)
- Posts: 3612
- Joined: 10 years ago