Slayer 1G pressure transducer piping
- Moots
- Posts: 28
- Joined: 7 years ago
I recently return home to Australia after 3 years overseas and got my Slayer out of storage. All fine except for a HTR ERR - STEAM SENSOR error. This was diagnosed as the pressure transducer (pic below), which I replaced and it's all working again. However, it's not a cheap part - A$670 - and apparently, because it is horizontal, moisture builds up in the transducer over time causing it to fail.
I have heard that you can modify or replace the piping to put it at an angle. Does anybody know anything about this?
Cheers
Paul
I have heard that you can modify or replace the piping to put it at an angle. Does anybody know anything about this?
Cheers
Paul
- CarefreeBuzzBuzz
- Posts: 3875
- Joined: 7 years ago