Before accessing this forum, please review the site's Terms of use . Pay careful attention to this reminder:
By accessing this forum, you agree to the site's Terms of use . If you do not agree with these terms, do not access the Repairs, Restorations & Mods forum.
I have a Vibiemme Domobar Super that is 17 years old. Usually when I turn it on to position 1 the pump would normally sound for 2-5 seconds however it has suddenly started taking 15-20 seconds before the pump turns off. I suspect something is about to fail. Has anyone...
We recently bought an old Pasquini Livia 90 and it turned out needed some attention.
I replaced the pump and it worked perfectly, but when I left the machine on, it shut off after a few hours, with only the power light on -- in case you're wondering it was not the water level....
Hi all, I recently purchased a PID Control Retrofit KIT for Rancilio Silvia from Auber. This kit will work on my Faema Family but I'm having difficulty determining where to connect the Auber power supply (VIA SSR). I have been unable to locate a Faema Family wiring schematic....
Greetings! I have successfully performed maintenance on my E61 grouphead once before. I have a rocket appartamento.
The machine is five years old, so I decided to get a generic set of replacement parts from blue-star-coffee for the E61, and set about replacing the old parts on...
i've done a complete renovation of the mushroom/E61 grouphead on a Izzo Alex Duetto 3.
Its really done magic. Only thing is that when i turn the machine on, the brewing pressure seem to go up to around 12 bar.. not that anything happens. But i have to open the lever up and down...
I want to know if there is a way to connect the solder points left behind after the timer/dose dial fell off. (I don't use it anyway)
It became detached after mounting screw fell out that held it to the circuit board.
I would appreciate any advice.
Fanks.
My Rancilio Silvia V1 wasn't steaming very well, so I took off the steam nozzle to clean it and found two small (head of a pin sized or a bit bigger) pieces of light green material inside. Under magnification It looks smooth and uniform so I'm guessing it's man-made...
Good morning coffee heads. I found an Enrico of Italy CE-12 in a small town antique shop for a few bucks. I know this is not a high quality machine, but it was cheap and looked like fun to restore. It is in decent shape but missing the drip pan and worst of all the portafilter....
Hi guys, reaching out here because I really need some input regarding how to troubleshoot my GS/3
Long story short, I was making a small service on the machine and tightened my expansion valve too tight. Heated up the machine and realised to late that I had blown my manometer,...
After 4 solid years of use, my Dual Boiler has started to give me some grief. The machine is taking longer to build up pressure, and is not getting to 9 bar. When it started happening, I descaled and cleaned the machine and it worked well for another few weeks, but it...