Slip on seal tool - Page 2

A haven dedicated to manual espresso machine aficionados.
3cordcreations

Postby 3cordcreations » Jun 25, 2019, 9:44 pm

walt_in_hawaii wrote:Jeez, can't leave your car keys unattended nowdays :(
Its a shame, Franz. I think stephen posted the dimensions and a sketch somewhere if anyone wants to make their own. Not too difficult.
If there's enough interest I could do a small run, been thinking I should make one for myself. Stainless is too expensive, I would probably just use aluminum as the seals are not hard enough to cause any wear to the tool...


Do people not like silicon seals? I used Cafelat seals on mine and were very easy to install without a tool and they last a long time...
A three cord strand is not easily broken...