3D Print of Drip Tray for 1st Gen La Pavoni, a better fit - Page 4

#31: Post by **ssh16** » December 5th, 2016, 11:28 pm

should we make it little higher? Seems extra space there

December 6th, 2016, 1:22 am

I agree. We could add 1 mm height. Here are more pictures. I would add 1mm to each side and 1 mm total depth (front to back). As it is it is quite usable.

#33: Post by **ssh16** » December 6th, 2016, 1:31 pm

I have published design here http://www.thingiverse.com/thing:1944929
This will be with 1mm added. Hope some one else will print it to check.
I will print one more for Gary this weekend

December 6th, 2016, 1:43 pm

Thank you, Sergey. I'm already putting the first one to good use!

#35: Post by **redbone** » December 6th, 2016, 3:43 pm

Nice work. Just have to find me a 3D printer now.

December 6th, 2016, 5:10 pm

check 3dhubs.com, there are several in your area who can print ABS

#37: Post by **JoeyDee9** » December 7th, 2016, 12:45 am

I'll print it out on my machine this weekend and post pictures. I'd set it to print sooner, but the machine needs some work...

#38: Post by **redbone** » December 7th, 2016, 10:35 am

ssh16 wrote:check 3dhubs.com, there are several in your area who can print ABS

Thanks for the link. Priced it out at $10.xx Canadian in ABS with pickup in 2 days.

#39: Post by **JoeyDee9** » December 7th, 2016, 11:57 pm

The fit is a bit off on my machine. A hair to big and a bit of slop in the sides. I'll sand it down by maybe 0.5 mm and it'll be great to use.

Ignore the bad original paint...it'd on my to-do list.

#40: Post by **redbone** » December 12th, 2016, 10:45 am

Just received my 3D print via 3Dhubs.