Height in cm of Mazzer Robur and Kony without hopper installed but with black collar on?

#1: Post by **AlMac** » August 28th, 2021, 11:43 pm

Dear Coffee Colleagues

I have looked, without any success, for the height of a Mazzer Robur and Kony (E or Automatic - not the new S models) from bench top to the top of the black collar the hopper sits in.

If anyone could please post that measurement in cms for one/both of them it would be very much appreciated.

I am trying to work out, with modding (hopper chopper, mazzer short hopper etc), if I can get them to fit under my cabinets in my pantry.

Not looking at any other grinders. It's this or stick with existing set up.

Thank you
Alec

#2: Post by **NelisB** » August 29th, 2021, 3:11 am

I will check my Robur this afternoon (European time)
This is what you mean, right? with the black collar

August 29th, 2021, 6:44 am

Yes, exactly thanks. The height of your Robur as per the picture is what I am after.

Thank you

Alec

#4: Post by **NelisB** » August 29th, 2021, 8:17 am

50.8 cm

August 29th, 2021, 9:34 am

Thank you very much.

A bit too tight the Robur.
Hopefully Kony can fit!

#6: Post by **NelisB** » August 29th, 2021, 9:44 am

The total height difference is 3 inch (7,6cm). So that must be minimal difference up to the collar.