Aligning a 2015 Mahlkonig EK43 - Page 4
- Jake_G
- Team HB
- Posts: 4336
- Joined: 6 years ago
Yes.
I've seen one on here.
Mahlkonig EK43S Chamber Alignment Confirmation
But sadly no link to the file.
I've seen one on here.
Mahlkonig EK43S Chamber Alignment Confirmation
But sadly no link to the file.
LMWDP #704
-
- Posts: 86
- Joined: 4 years ago
Okay so I ended up getting the burr alignment tool from a friend, but I can't seem to fit it on the drive shaft of the fixed burr. At least one arm is on the edge of the burr as opposed to all three arms on the outside of the burr. I also can't fully rotate the tool.
Edit: is there a better way to align the fixed burr? Or is there a different version of this tool that's better for older EKs
Edit: is there a better way to align the fixed burr? Or is there a different version of this tool that's better for older EKs
- bostonbuzz
- Posts: 1262
- Joined: 13 years ago
A simple magnetic indicator holder will sit on the shaft without moving. I think mine was from Amazon ten years ago for 10$.
LMWDP #353