Quick Mill pulsor to make vibratory pump quieter

Need help with equipment usage or want to share your latest discovery?
Eiern
Posts: 627
Joined: 9 years ago

#1: Post by Eiern »

Installed a Quick Mill Pulsor today





Also tried a EX4 pump replacing the EX5 pump but it was just too slow even without the gicleur in the group.

I have ordered a rotary pump + motor and will have that mod done hopefully next week. Vibe pump sounds OK in use but sound very bad played back from a recording.

JRising
Team HB
Posts: 3667
Joined: 5 years ago

#2: Post by JRising »

I'm not criticizing, just curious...
Would it fit better with the pulsor directly to the pump outlet without the elbow?

Eiern (original poster)
Posts: 627
Joined: 9 years ago

#3: Post by Eiern (original poster) »

I think it might hit the back plate of the machine if the angle would be replaced by this, the white part would be toward the back plate.