Before accessing this forum, please review the site's Terms of use . Pay careful attention to this reminder:
By accessing this forum, you agree to the site's Terms of use . If you do not agree with these terms, do not access the Repairs, Restorations & Mods forum.
I've had a Linea Mini for about 5 years and haven't had any major issues with it.
However, yesterday morning I noticed that the steam is not as dry as it used to be and it spits out more water than before. My wife also noticed that when the steam boiler is louder when heating...
I have a well maintained Izzo Duetto IV which is 2 years old and has a flow control kit.
I backflush 5x back to back once a week and the same but with detergent once every 3-4 months. Everything works fine - no pressure problems during brewing, excess tray dripping etc. V....
We are coming up on two years of ownership of a Breville Dual Boiler. Between my spouse and I, we average 4-5 uses a day.
I noticed recently that there is a low volume hissing sound coming from the machine - already checked the wand, that's not it. Any other ideas? If there is...
I have a SAB Jolly Auto 2gr that is not holding a program. Both group heads are running and both the touchpads work. I've checked the flow meters and they seem ok. I'm getting the light flicker on both when in use. The problem I'm having is that the group head will run...
I recently purchased a used BDB 920 and had been enjoying it over the past couple of months.
Unfortunately, a couple of weeks ago when I went to pull a shot I got little to no flow from the group head. Hot water comes out from the spout and the steam wand...
I found a Gaggia Classic on ebay and got it for $220 (plus $40 shipping). I looked at all the PiDs available--Guaggauino (overkill), SunGaze, Aliexpress XTM7100, Shades O' Coffee and Barista Gadgets. All said and done, I just wanted good temperature control and nice, sleek look...
I have a Vibiemme Domobar Super that is 17 years old. Usually when I turn it on to position 1 the pump would normally sound for 2-5 seconds however it has suddenly started taking 15-20 seconds before the pump turns off. I suspect something is about to fail. Has anyone...
Dear Pros,
My Brasilia club keep pushing out the gasket -3 times. The 3rd time, it push gasket out when PID temperature is just 32 degrees.
Some people commented that because there is gap between upper part and lower part of boiler. Yes, when I bought it from owner, upper part...
I have a plumbed in ECM Synch. I run from 8am-11pm most days so that it's available when desired. I usually pull 1-2 shots a day on average (decaf on many nights, and some mornings or afternoons a shot or a few shots depending on if I'm drinking filter).