Before accessing this forum, please review the site's Terms of use . Pay careful attention to this reminder:
By accessing this forum, you agree to the site's Terms of use . If you do not agree with these terms, do not access the Repairs, Restorations & Mods forum.
I recently purchased a used BDB 920 and had been enjoying it over the past couple of months.
Unfortunately, a couple of weeks ago when I went to pull a shot I got little to no flow from the group head. Hot water comes out from the spout and the steam wand...
So I just picked up a refurb BZ13 for work and I've been test driving it at home.
The steam pressure is much weaker than I'd expect for the ~1.3 bar that it should be running at given the temperature I have set on the PID. My other machine is a Silvia Pro which also maxes out...
Dear Pros,
My Brasilia club keep pushing out the gasket -3 times. The 3rd time, it push gasket out when PID temperature is just 32 degrees.
Some people commented that because there is gap between upper part and lower part of boiler. Yes, when I bought it from owner, upper part...
I have a Vibiemme Domobar Super that is 17 years old. Usually when I turn it on to position 1 the pump would normally sound for 2-5 seconds however it has suddenly started taking 15-20 seconds before the pump turns off. I suspect something is about to fail. Has anyone...
Just recently the Clean light came on , on my Breville BES840 Infuser, nothing unusual really, however when trying to back clean and also when trying to descale, these functions would not work. The light is still on but the machine is still producing the same coffee and...
Hi all.
The ice storm knocked out power for a couple of days now. Before power went out, it was flickering a few times.
Usually the machine is on 24/7, has been for over 3 years.
I have the house now on a gasoline generator. When I flip on the switch , the green light is on....
The wire connections to the heating element in my Bonavita (BV1900TS) burned out. I have ordered the correct thermal fuse to solder on the wire and new connectors, but I'm not sure which wire to buy or where. Can someone please help me identify the wire that needs replacing?...
We are coming up on two years of ownership of a Breville Dual Boiler. Between my spouse and I, we average 4-5 uses a day.
I noticed recently that there is a low volume hissing sound coming from the machine - already checked the wand, that's not it. Any other ideas? If there is...
I purchased an old and still functional Rancilio Silvia and wanted to replace the badly rusted steel frame.
I purchased a stainless steel frame and proceeded to dismantle the old machine; wow, the rust is unbelievable. But that's a different story.
In the process, I wanted to...