Before accessing this forum, please review the site's Terms of use . Pay careful attention to this reminder:
By accessing this forum, you agree to the site's Terms of use . If you do not agree with these terms, do not access the Repairs, Restorations & Mods forum.
I found a Gaggia Classic on ebay and got it for $220 (plus $40 shipping). I looked at all the PiDs available--Guaggauino (overkill), SunGaze, Aliexpress XTM7100, Shades O' Coffee and Barrista Gadgets. All said and done, I just wanted good temperature control and nice, sleek look...
I have a Vibiemme Domobar Super that is 17 years old. Usually when I turn it on to position 1 the pump would normally sound for 2-5 seconds however it has suddenly started taking 15-20 seconds before the pump turns off. I suspect something is about to fail. Has anyone...
Dear Pros,
My Brasilia club keep pushing out the gasket -3 times. The 3rd time, it push gasket out when PID temperature is just 32 degrees.
Some people commented that because there is gap between upper part and lower part of boiler. Yes, when I bought it from owner, upper part...
I recently purchased a used BDB 920 and had been enjoying it over the past couple of months.
Unfortunately, a couple of weeks ago when I went to pull a shot I got little to no flow from the group head. Hot water comes out from the spout and the steam wand...
I have a plumbed in ECM Synch. I run from 8am-11pm most days so that it's available when desired. I usually pull 1-2 shots a day on average (decaf on many nights, and some mornings or afternoons a shot or a few shots depending on if I'm drinking filter).
Pulled a shot and steamed milk for a latte. All functioned fine and results were perfect. Steam pressure good. Grouphead pressure good at the gauge. Boiler temp. good.
Minutes later while making 2nd Latte, grouphead pressure dropped amid pull, steam pressure dropped and steam...
Hi all.
The ice storm knocked out power for a couple of days now. Before power went out, it was flickering a few times.
Usually the machine is on 24/7, has been for over 3 years.
I have the house now on a gasoline generator. When I flip on the switch , the green light is on....
I have an Alexa Leva who's pressure relief value blew yesterday morning, generating much noise and excitement.
I've removed cover, peeked around, and now just turned it back on. It seems to be working normally (for last 30 min). The PID is set to 250. Temp reached and then...
So I just picked up a refurb BZ13 for work and I've been test driving it at home.
The steam pressure is much weaker than I'd expect for the ~1.3 bar that it should be running at given the temperature I have set on the PID. My other machine is a Silvia Pro which also maxes out...
Just recently the Clean light came on , on my Breville BES840 Infuser, nothing unusual really, however when trying to back clean and also when trying to descale, these functions would not work. The light is still on but the machine is still producing the same coffee and...