I picked up a non-functional Fiorenzato Bricoletta to repair, and I started tearing it down to clean it before really digging into the problem... and I don't recognize this part. I did a quick browse on espressoparts.com to see if I could visually match it, but had no luck. I...

Hi there, so im to do an overhaul on my ulka pump since not much pressure is being made with my espresso machine and ruled out descaling, grinds or opv. the small ball seems fine but im replacing it with a glass bead and I ordered a set of O rings. The new ones are softer than...

Hi,
I recently purchased a used BDB 920XL from a small coffee shop. According to the owner she purchased back in December 2022 with an assumption that could handle the workload but after a month she realized she needs a commercial machine. She told me the machine pulled 250...

I've got a Breville oracle that had one of it's PTFE tubes break. When it broke it leaked some water, the steam boiler overheated and the thermal fuse blew. After that it wouldn't heat to temp, never going above 158F.

So I replaced the thermal fuse on the steam boiler. Now the...

I was joking initially when I quipped that someone should just print a new drip tray to get rid of the reservoir hump. Maybe half joking...

Printed from ASA that is labeled to have a working temp of 100°C, I think it will hold up to my light use but we shall see.

The original...

Hello, everyone. Some years ago, the steam boiler failed on our Delognhi ESAM5500 machine, and I replaced it with a newer Delonghi machine. However, I recently decided to try to fix it. I replaced the steam boiler and one of the two solenoid valves, and it now works --...

This is for the Livia 90 and some Bezzera machines.
The filter, with the valve below is loose on the bottom of the tank. How do I remove/tighten it?
Thanks

Hello,

I've been wanting to get into coffee machine repair for a while now and it would seem that my prayers have been answered by a cheap Barista Express from a junk shop. I've cleaned it up and run some water through it but it seemed to have trouble holding it's water as it...

Hello fellow coffee lovers.

I was hoping someone might be able to help me with some technical issues I've been having with my machine. Now it's generally a consistent and overall good machine. But lately its been acting a little weird. Now since I've got it (number 2 owner)...

Hey Folks,

I'm in the process of refurbishing an otherwise excellent Dalla Corte Mini espresso machine and the vibe pump supports are shot - I've never liked the std high-durometer black rubber supports/mounts.

Has anyone found a good solution, something like a softer...