Below is a collection of this forum's most popular topics. To nominate a thread for inclusion in this list, please post a reply to this message. Remember to check the Resources page for other references.
I have had a DF83 V2 for about 3 months now and am using the SSP Cast Burrs with it for espresso. Overall pleased with the results. The one super annoying thing is that as I grinder for a few shots in the morning the grinder warms up and the zero will drift...
I recently switched to SSP Cast burrs V2 silver and I cannot get decent shot to shot consistency out of . Shots can be 31 seconds and the next one 17 seconds, then 45 seconds. Every else staying the same.
I've read a lot about them before purchasing. I read about those having...
Can you post a picture of your filled baskets please? I have seen a few videos and it doesn't seem to be perfectly distributed ready for tamping? I have seen a teardown and there is apparently a wiper inside the bottom cone to free off any attached grinds. I was wondering if a...
I have a Rocket Faustino grinder and it seems to grind the first two or three doses (usually 18g) a lot finer than subsequent doses. It has consistently done this for a number of months. It means if I only pull one or two shots, I can keep it consistent, but if I have...
Any thoughts on what it could be? As a Mazzer fan I'm curious to find out. Probably a commercial grinder but would be great if it was a home-market GBW.
I just got a Weber Key grinder. The recomended grind speed is about 70RPM. It takes about a minute to grind 16g. My previous grinder, a Baratza Sette 270Wi sounded like it ground at 10,000RPM. It would grind 16g in about 10 seconds. I'm gladly giving up that speed for the super...
I recently got a secondhand rock grinder and I broke the bevel gear grinding for espresso... Twice
It is a gc version but the steps on the wheel are completely flattened, it doesn't click at all and so I suspect that my zero point was too tight, meaning...
