Below is a collection of this forum's most popular topics. To nominate a thread for inclusion in this list, please post a reply to this message. Remember to check the Resources page for other references.
I recently switched to SSP Cast burrs V2 silver and I cannot get decent shot to shot consistency out of . Shots can be 31 seconds and the next one 17 seconds, then 45 seconds. Every else staying the same.
I've read a lot about them before purchasing. I read about those having...
Out of the box issue with the DF54, unfortunately...
When adjusting the grind from 75 to 15 and running the motor it appears that the burrs are 'locked' or 'jammed' and not spinning freely. I can't turn the adjustment collar past 65 at which point the burrs become locked and...
Anybody know anything at all about the Zerno grinder?
I'm likely content with my Niche for a while, but it appeared on my Instagram feed and looks like another potential addition to the new wave to single dose grinder.
I have had a DF83 V2 for about 3 months now and am using the SSP Cast Burrs with it for espresso. Overall pleased with the results. The one super annoying thing is that as I grinder for a few shots in the morning the grinder warms up and the zero will drift...
Can you post a picture of your filled baskets please? I have seen a few videos and it doesn't seem to be perfectly distributed ready for tamping? I have seen a teardown and there is apparently a wiper inside the bottom cone to free off any attached grinds. I was wondering if a...
I have a Rocket Faustino grinder and it seems to grind the first two or three doses (usually 18g) a lot finer than subsequent doses. It has consistently done this for a number of months. It means if I only pull one or two shots, I can keep it consistent, but if I have...
Any thoughts on what it could be? As a Mazzer fan I'm curious to find out. Probably a commercial grinder but would be great if it was a home-market GBW.
I just got a Weber Key grinder. The recommended grind speed is about 70RPM. It takes about a minute to grind 16g. My previous grinder, a Baratza Sette 270Wi sounded like it ground at 10,000RPM. It would grind 16g in about 10 seconds. I'm gladly giving up that speed for the super...