Below is a collection of this forum's most popular topics. To nominate a thread for inclusion in this list, please post a reply to this message. Remember to check the Resources page for other references.
I just got my Weber EG-1 today.
As a first try, I headed to dial in my espresso. I started with locking in my core burrs against each other to get to the absolute zero point. Then I adjusted as the Weber support rep suggested, by changing the grind size 4-6 full numbers...
I recently switched to SSP Cast burrs V2 silver and I cannot get decent shot to shot consistency out of . Shots can be 31 seconds and the next one 17 seconds, then 45 seconds. Every else staying the same.
I've read a lot about them before purchasing. I read about those having...
I recently got a secondhand rock grinder and I broke the bevel gear grinding for espresso... Twice
It is a gc version but the steps on the wheel are completely flattened, it doesn't click at all and so I suspect that my zero point was too tight, meaning...
I have a Sculptor 078 on the way, and have an unopened never used Fellow Ode w SSPs, outside of a return window. I'm curious if anyone has tried both / has both and if they produce very different cups ?
I'm considering just keeping the Ode as well if I can't resell it for...
I have had a DF83 V2 for about 3 months now and am using the SSP Cast Burrs with it for espresso. Overall pleased with the results. The one super annoying thing is that as I grinder for a few shots in the morning the grinder warms up and the zero will drift...
Out of the box issue with the DF54, unfortunately...
When adjusting the grind from 75 to 15 and running the motor it appears that the burrs are 'locked' or 'jammed' and not spinning freely. I can't turn the adjustment collar past 65 at which point the burrs become locked and...
Anybody know anything at all about the Zerno grinder?
I'm likely content with my Niche for a while, but it appeared on my Instagram feed and looks like another potential addition to the new wave to single dose grinder.
Can you post a picture of your filled baskets please? I have seen a few videos and it doesn't seem to be perfectly distributed ready for tamping? I have seen a teardown and there is apparently a wiper inside the bottom cone to free off any attached grinds. I was wondering if a...
