Below is a collection of this forum's most popular topics. To nominate a thread for inclusion in this list, please post a reply to this message. Remember to check the Resources page for other references.
I just got a Weber Key grinder. The recomended grind speed is about 70RPM. It takes about a minute to grind 16g. My previous grinder, a Baratza Sette 270Wi sounded like it ground at 10,000RPM. It would grind 16g in about 10 seconds. I'm gladly giving up that speed for the super...
So on IG Weber teased a video of a new bean feeder and a two-part cover that looks to replace the funnel. I've already asked if a retrofit will be available for existing Keys.
The bean feeder now has only one hole - which is good. I had found both holes open was too much for...
I just got my Weber EG-1 today.
As a first try, I headed to dial in my espresso. I started with locking in my core burrs against each other to get to the absolute zero point. Then I adjusted as the Weber support rep suggested, by changing the grind size 4-6 full numbers...
Any thoughts on what it could be? As a Mazzer fan I'm curious to find out. Probably a commercial grinder but would be great if it was a home-market GBW.
Anyone has any idea where I can find a rubber feet replacement for Niche Zero? I noticed a couple of days ago that my grinder is wobbly and upon further inspection I realized that one of the rubber feets (inside the wooden feet) is missing and I cannot find it. I searched in...
I've come across a claim a few times that goes something like this: perfectly aligning your burrs (for example, via shims and the marker test) does not improve your grinder's performance because that alignment gets distorted once the burrs are grinding beans. I think the idea...
