Below is a collection of this forum's most popular topics. To nominate a thread for inclusion in this list, please post a reply to this message. Remember to check the Resources page for other references.
Just want to get some opinion on this theoretical pressure profile curve...
The idea is to let pre-infusion happen at 2-2.5 bar until first drop, then start with this spring profile
Do you think this would be a good starting point from build?
I recently purchased a Bezzera Strega TOP, which I am so far loving. I wanted to check the PI and brew pressure and to see how they ramp and decline. I also wanted to verify what pressure the OPV is actually set to. The dealer told me 15 bar, while I've read 11bar...
I'd like to get my Cappuccino Amore CE-14 in working order. I see I'm a little late to the party from the closed conversations, so I'm opening this one.
I'm in need of a pressurized cap/lid for this machine, and a portafilter basket. Does anyone know if there is a make/model of...
I'll write more as I get used to the new machine but initial impression is even better than hoped! This has been an almost 2 year wait (August '21). Fit and finish are top notch. Very well thought out. Pleasantly surprised as I was...
I currently have a Cremina and I use the one hole steam tip with some success. I found that with the right milk pitcher It can make all the difference but even then it is not easy to get consistent results. Sometimes it makes the perfect micro foam and other times it is globs of...
I've never used an espresso maker of any kind before! :D But I'm helping a family member get a 1985 Olympia Cremina back into operation, which seemed to be in excellent condition except that water would force itself out of the group before the machine fully came up to...