Search found 27 matches

by sctsprin
October 18th, 2016, 9:51 pm
Forum: Grinders
Replies: 209
Views: 23151

Lyn Weber Workshops EG-1 User Experiences

Here's my retention and distribution after making an espresso {image} {image} {image}
by sctsprin
October 17th, 2016, 7:09 pm
Forum: Grinders
Replies: 209
Views: 23151

Lyn Weber Workshops EG-1 User Experiences

Okay thanks for the info Chris
Advertisement
by sctsprin
October 17th, 2016, 5:21 pm
Forum: Grinders
Replies: 209
Views: 23151

Lyn Weber Workshops EG-1 User Experiences

I only get fines around the top carrier if I don't RDT, otherwise I get almost nothing sticking there I remove the shaker, give it a tap to settle all static cling fines and the little bit sitting on the top of the handle, put the lid on, shake vertically and swirl horizontally, another tap on the m...
by sctsprin
October 4th, 2016, 9:53 pm
Forum: Grinders
Replies: 209
Views: 23151

Lyn Weber Workshops EG-1 User Experiences

it's 385mm
by sctsprin
October 1st, 2016, 3:04 am
Forum: Grinders
Replies: 209
Views: 23151

Lyn Weber Workshops EG-1 User Experiences

Yep, that'll work
by sctsprin
September 30th, 2016, 10:40 pm
Forum: Grinders
Replies: 209
Views: 23151

Lyn Weber Workshops EG-1 User Experiences

A nice timber plug for the hole would be good to keep bugs out
by sctsprin
September 30th, 2016, 9:15 pm
Forum: Grinders
Replies: 209
Views: 23151

Lyn Weber Workshops EG-1 User Experiences

{image} Here ya go
by sctsprin
September 24th, 2016, 6:28 am
Forum: Grinders
Replies: 209
Views: 23151

Lyn Weber Workshops EG-1 User Experiences

Less than 0.1g without RDT, but you get a fine mist stuck to the bottom of the exit shoot You can grind straight into the basket, (just clamp it up high) with no mess, but it's slightly off centre No clumping, until you shake or WDT, then you can get some removing the shaker or funnel You don't have...
by sctsprin
September 1st, 2016, 12:10 am
Forum: Grinders
Replies: 209
Views: 23151

Lyn Weber Workshops EG-1 User Experiences

I took the funnels off and listened to the sound as the motor ran, it was giving a pulsing uneven sound then i took off the wipers and a lot of the rubbing sound went away, which makes sense, but a bit of an uneven sound was still there at different rpms So i opened up the burrs and ran
by sctsprin
August 31st, 2016, 2:54 am
Forum: Grinders
Replies: 209
Views: 23151

Lyn Weber Workshops EG-1 User Experiences

So I can confirm from the manufacturer that the grinder has current protection to prevent over heating or damage. And the system senses when you hit a hard bean and increases the motor power to grind it, very clever