Search found 38 matches
- April 26th, 2022, 10:01 am
- Forum: Repairs, Restorations & Mods
- Replies: 3
- Views: 106
Vibiemme Domobar Junior HX - water gushing from vacuum breaker
either the control board and or the earth wire on the top of the boiler...or even the water level probe dirty or corroded
- September 10th, 2019, 12:35 am
- Forum: Espresso Machines
- Replies: 8
- Views: 826
My story with Elektra and Microcasa Semiautomatica SXC
A question - was the machine serviced every 12 months with seals, gaskets & / or o-rings replaced ?
- December 20th, 2018, 11:30 pm
- Forum: Marketplace
- Replies: 53
- Views: 3910
Versalab M3 alignment kit
+1 : well said Assaf
- December 2nd, 2018, 6:46 am
- Forum: Marketplace
- Replies: 53
- Views: 3910
Versalab M3 alignment kit
Hi, I don't need it at the moment but would be interested for if / when I need to dismantle my M3 - good suggestion re: video / pics etc regards dino
- May 30th, 2018, 10:27 pm
- Forum: Marketplace
- Replies: 61
- Views: 8353
Versalab M3 Grinder thoughts
leozava , did you change to a toothed belt ? or keep the VL belt and pulleys ? did you fit the 6037 and control board inside the VL or just the 6037 with the control board externally ? any pics available ? regards dino
- April 27th, 2018, 9:46 am
- Forum: Grinders
- Replies: 39
- Views: 2576
My Versalab won't grind Black Cat [UPDATED: now it will]
cool - looking forward to it!
- April 19th, 2018, 5:20 am
- Forum: Grinders
- Replies: 39
- Views: 2576
My Versalab won't grind Black Cat [UPDATED: now it will]
Hi Assaf , will the 6035 fit with the bodine speed controller inside the VL. Also, a new rear pulley or drill out the pulley for the 6035 shaft ? A new thermal cut out switch ? regards, Dean
- May 25th, 2017, 6:56 am
- Forum: Buying Advice
- Replies: 64
- Views: 6998
Versalab M3 vs. Others
Hi Rush, are there any updates on your grinder ? has it been seen to by terranova ? regards dino
- April 15th, 2017, 9:34 am
- Forum: Grinders
- Replies: 10
- Views: 1294
Looking for Voodoodaddy Pharos Mod Instructions
Instructions as per email from Will back in 2012 minus the photos ( sorry they have disappeared ) First we need to disassemble everything, only leaving the top plate, middle plate, outer burr, clear PVC tubing and the four inner mounting bolts. Brush clean the burr set. Center the outer burr to the ...
- March 28th, 2017, 7:01 am
- Forum: Grinders
- Replies: 9
- Views: 2648