Recent posts - Page 47
- April 20th, 2024, 5:01 am
- Forum: Repairs, Restorations & Mods
- Replies: 2
- Views: 34
2019 Gaggia Classic Pro, Indicator Light Issue
I recently purchased (in New Zealand) a second hand GCP for my sister, it was very cheap but not without problems! Someone had stripped the screw holding the shower screen in place, which in the end was relatively simple to remove. The main issue though is that the ON OFF indicator light only partially worked when I received
- April 20th, 2024, 4:43 am
- Forum: Grinders
- Replies: 282
- Views: 27322
The new DF83v
I have not personally had previous experience with df64coffee.com but I do know someone who has ordered 7 or 8 griddners from them previously (as well as burrs) and have not had issues (ie they always fulfil orders, and I'm told they do a good job aligning them as they are NOT pre-aligned from the factory). I believe they
- April 20th, 2024, 4:20 am
- Forum: Blog
- Replies: 56
- Views: 3705
Mazzer Philos Comments
What does hyperaligned mean and how is it measured? Does this concern machining tolerances or mounted burr runout measured by deflection gauge? I am quite confused by the idea that only small, boutique manufacturers can produce well aligned grinders. Perhaps big manufacturers haven't focused on it, but I'd bet that they're the ones that can scale up production
- April 20th, 2024, 4:17 am
- Forum: Grinders
- Replies: 6
- Views: 429
Sculptor 078 & Ode SSP - keep both?
I agree, I have both out side by side on the bench right now and I struggle to find a reason to use the ode over the 078
- April 20th, 2024, 4:16 am
- Forum: Repairs, Restorations & Mods
- Replies: 0
- Views: 16
Bypass dose timer of Eureka Mignon MK2
I want to know if there is a way to connect the solder points left behind after the timer/dose dial fell off. (I don't use it anyway) It became detached after mounting screw fell out that held it to the circuit board. I would appreciate any advice. Fanks
- April 20th, 2024, 3:38 am
- Forum: Blog
- Replies: 56
- Views: 3705
Mazzer Philos Comments
Thank you for your explanation but I was just wondering if I need to calibrate it to zero before I start using the grinder If it's factory calibrated I don't hv to, I'm a bit OCD, I must complete this procedure before using
- April 20th, 2024, 3:38 am
- Forum: Repairs, Restorations & Mods
- Replies: 4
- Views: 172
Help with brew pressure on izzo espresso machine
Is it possible to get one of you, to show it on a diagram of the machine? Which it's about