actually they can't. i was the buyer, not the seller. but i ordered the courier. i anticipated that they would try it. so I photo'd the packaging which i also pointed out that if there were concerned yet took the package then they are still responsible as they accepted the deal when they could have refused to take the package

Thanks for opening this thread -- it was great meeting everyone

{image} Better picture maybe

i haven't yet tested the electronics themselves although the front touch panel would certainly require replacing. i found a bit of it in the box that could be glued to the rest but i'm not optimistic it would work. i wouldn't say i was a major expert at electronics, but i've repaired a few small bits in my time. what

I find that for immersion brewing, I have to give it over a full turn, about 1 1/4, from the lock point, for best results. I like a more concentrated brew 12.5 to 15 to 1, and a coarser than usual grind when using it for very light roasts

Noticed today my Lucca wasn't heating up when I turned it on. Went on Clive coffee and they said to go press the reset on the safety switch and it should probably work. Took the panels off and noticed this burnt connection... I'm assuming I need to replace this. My two questions are, would the safety switch on

Step 1 - pull, photograph & clean steam boiler fill probe and take it from there

FWIW, Another technique I use which helps to reduce air entrapment on my v2 F58 is when the lever is down, I lift up slightly on the lever just enough to open the valve, start pouring water while raising the lever and finishing the fill. Something else to try. FWIW, I have the same generation of F58 as the

We recently bought an old Pasquini Livia 90 and it turned out needed some attention. I replaced the pump and it worked perfectly, but when I left the machine on, it shut off after a few hours, with only the power light on -- in case you're wondering it was not the water level. Long story short, we

Hello fellow coffee lovers. I was hoping someone might be able to help me with some technical issues I've been having with my machine. Now it's generally a consistent and overall good machine. But lately its been acting a little weird. Now since I've got it (number 2 owner) it's only been in plumbed mode with bwt filter