Saw these were opened for preorder today, thinking about them as a replacement for the stock burrs in my DF64. Some videos I've seen on the Ditting 804s have me very intrigued!

Hi I am looking for help with Artisan Settings for my 2016 version North TJ-067 (now Mill city 1k) roaster. I am using a phidget 1048 and so far I installed the drivers from phidget without any further tweaking. I chose Phidget USB 1048 as my machine and device with default...

Help ! I own two Eureka grinder's one is the specialita for espresso and 1 brew pro for filtered. The brew pro has been a pain of mine from day one it does not go coarse enough for a Chemex and there are too many fines, Thus leaving me with over extracted coffees. Companies keep...

Measures: 15 x 11 5/8 x 3 1/4 . Commercial grade thick stainless steel. Made by Pasquini, will last a lifetime. Can be used to keep all your espresso accessories right at hand under your machine, or as a big knock box in a commercial operation. (Espresso machine sits on top of...

I have an OE Lido that has been grinding away gone 10+ years now. Unfortunately my missus decided to see how much abuse it could take the other day and ended up breaking the catch cup AND the black plastic top it threads into. I went to the OE Lido site to try and buy a new one...

Looking for a nice home setup semi auto machine for brewing a couple shots each morning. Only must have is that it needs to have a water reservoir/can't be plumbed in. I've had super autos in the past but time to fully upgrade. Loved my old school lever machine but would like...

Fresh Roast SR800, 1750 watts 15 amp. Hoping 12awg/3 25 footer and hopefully copper would be ok. I'm aware an extension cord is not recommended. 25 > 10'. 10 gauge less options and more expensive but I'll do what I gotta, any input ?

Some of you know the history of this machine from following my original thread: The Mysterious Profitec Pro 300 . For those who are new to this machine here's the quick facts:

So this is a relatively unique little machine. I was originally pretty sold on the BDB, but I was...

There's very little information on it here, especially when it comes to comparing with the Ikawa offerings. I hope we can start a discussion and maybe be lucky enough to have Australian users provide feedback on their units. The thread I found here was pretty short.

I've designed a new exit chute for the DF64 to address retention and static issues with the stock grinder. I imagine this may be of interest to readers that either have a 3D SLA printer or know someone that does. There are a lot of makers out there, and I bet most of them drink...