I'm looking at a Quick Mill Anita on CL
of uncertain age, steam wand through front panel, so prolly not EVO.
What are the models and is there a SN# with date info on this?
Clean and asking $750 USD, which is high, but if I sell my Silvia it's do able, and he may come down
They...

I'm not aware of a thread that showcases member setups so thought I would start one. Here is my baby (mazzer mini, autotamp, vibiemme domobar super + e61 thermometer):

Now I just need to add skills and might be getting somewhere. Newest editions are the E61 thermometer...

First off, hi! I'm new around here.

I'll get right down to it. Should I replace this older generation Silvia boiler with a new one or does it just need a good cleaning?

I bought an older Silvia to tinker with and the first thing I did was to dismantle the poor thing.

I'm looking to buy New baskets which do you recommend? Thank you

Got the new Linea Mini home just last night after picking it up at Clive Coffee here in Portland. Clive held a nice open house event on Memorial Day where they invited customers down to the store to try out some of the new equipment and check out some of their open box buys....

Would it be possible for the Lever Forum to have a Gallery sticky of all the lever machines? If we own/owned the machines there would be no copyright issues. I think it would be helpful to all us LeverLovers to be able to see machines referred to in the forums quickly, without...

I was assaulted over the weekend at work and broke a rib. Of course it's my dominant side so pulling shots is definitely not fun with that arm at the moment. Honestly never tried this before but managed to pull an acceptable shot. Not near my normal pulls but drinkable. I will...

After a long time lurking on this forum and being inspired by the very many threads, I took the plunge and decided to make a project out of refurbishing a lever. First a tour of the machine:

This is a 1957 2nd gen Urania - mid generation single group. It has a 1st gen...

I've a Bezzera which has a problem with power trips.

I've disconnected the heating element and pump and it still trips.
It's annoying and probably dangerous each time it trips, it also pulls the circuit breaker and shut the whole place

How do repair centres isolate and keep...

It's been little over a year since I replaced the piston gaskets and now I need do to it again (same symptom of water spurting from the back of the group).

Could the relatively fast degradation be related to the fact that my MCaL is set to 1.2 bar and is powered on for several...