I get Aeropress but, on the road that doesn't generally do it for me. I don't do the ~$8 Starbucks thing either with any frequency but, occasionally hit Tim Hortons and similar shops when traveling in big cities to try the local style! I'm more into cowboy or French Press coffee...

I received a Moccamaster select for Christmas from my wife and kids. My question is about the 1/2 pot versus the whole pot switch. Does it matter? When do you switch from 1/2 to whole? If you pass the halfway mark when do you switch over to full. I only make the amount of coffee...

Looking for a Niche Zero in excellent condition. I am located between Austin and San Antonio, Texas. I will also be in Bentonville, Arkansas for most of May. Would prefer local pickup but for the right deal I would be open to shipping.

Let me know if you have one! Thanks all.

Folks,

I have had a DF83 V2 for about 3 months now and am using the SSP Cast Burrs with it for espresso. Overall pleased with the results. The one super annoying thing is that as I grinder for a few shots in the morning the grinder warms up and the zero will drift...

Hello! I was sent here from Reddit. I purchased a Rancilio Silvia last week. When I turned it on everything seemed to work fine. I flipped all the switches on, pump was work, water came out of the group head but as soon as I opened up the nozzle for steam, it tripped the GFCI...

I currently have a Cremina and I use the one hole steam tip with some success. I found that with the right milk pitcher It can make all the difference but even then it is not easy to get consistent results. Sometimes it makes the perfect micro foam and other times it is globs of...

I recently switched to SSP Cast burrs V2 silver and I cannot get decent shot to shot consistency out of . Shots can be 31 seconds and the next one 17 seconds, then 45 seconds. Every else staying the same.

I've read a lot about them before purchasing. I read about those having...

Just want to get some opinion on this theoretical pressure profile curve...
The idea is to let pre-infusion happen at 2-2.5 bar until first drop, then start with this spring profile
Do you think this would be a good starting point from build?

Being theoretical, it doesnt...

Hi all,

After 4 solid years of use, my Dual Boiler has started to give me some grief. The machine is taking longer to build up pressure, and is not getting to 9 bar. When it started happening, I descaled and cleaned the machine and it worked well for another few weeks, but it...

Out of the box issue with the DF54, unfortunately...

When adjusting the grind from 75 to 15 and running the motor it appears that the burrs are 'locked' or 'jammed' and not spinning freely. I can't turn the adjustment collar past 65 at which point the burrs become locked and...