Recent posts
- 1 hour ago
- Forum: Coffee Brewing
- Replies: 52
- Views: 2944
Fellow Aiden anyone?
I'd have to think the main advantage is the brewing temps for certain roasts give it the slight edge over a steady temp with the moccamaster if going off of my experience with an espresso machine but I'm not a next level coffee guy so who knows
- 1 hour ago
- Forum: Coffee Brewing
- Replies: 52
- Views: 2944
Fellow Aiden anyone?
Don't take this the wrong way but that's saying a lot without saying anything at all
- 1 hour ago
- Forum: Grinders
- Replies: 1
- Views: 107
Sculptor 078 & Ode SSP - keep both?
you could always keep it and try the difference or slap different burrs in the Ode. I'm curious if the 078 versus SSP MP 64MM still holds up
- 1 hour ago
- Forum: Espresso Machines
- Replies: 6
- Views: 48
Domobar Jr Hx Temps
You can't. That's the point. You are setting the size of the restriction. You are not directly controlling flow or pressure. You have to watch the stream for flow rate and the manometer for pressure and adjust the valve as you go. There's a recent discussion of this here at "Understanding Brew Pressure, Flow, Valves, and "Slayer Shots""
- 1 hour ago
- Forum: Espresso Machines
- Replies: 1
- Views: 38
Linea Mini solenoid issue
May I know what kind of water do you use ?
- 1 hour ago
- Forum: Blog
- Replies: 51
- Views: 3002
Mazzer Philos Comments
Dear reviewer, May I know does it come factory zero chirping or I have to self-calibrate to zero chirping ?
- 1 hour ago
- Forum: Espresso Machines
- Replies: 6
- Views: 48
Domobar Jr Hx Temps
If the temperature is 200°F, it's the brew temperature. I ran an e61 HX boiler @ ≈227°F for mid 190's brew temperature
- 1 hour ago
- Forum: Coffee Roasting
- Replies: 18
- Views: 387
Any alternative to Behmor?
Price. Something that can also roast a pound at a time that has actual control over what you're doing is in the $2k plus range. Maybe that is changing now with some of the Ali express roasters mentioned
- 1 hour ago
- Forum: Lever Espresso Machines
- Replies: 11
- Views: 200
Arthritis and the Argos boiler cap
Hey folks....Ross has a 3-D printed wrench he uses in the shop. He's offered to send me one. Will report back. And a big shout out to Ross
- 2 hours ago
- Forum: Repairs, Restorations & Mods
- Replies: 5
- Views: 53