Recent posts
- 6 minutes ago
- Forum: Marketplace
- Replies: 1971
- Views: 330393
Custom Wood for your Espresso Machine
Now this is the kind of content that is truly inspirational. Dave, I've sent an email
- 7 minutes ago
- Forum: Coffee Roasting
- Replies: 19
- Views: 395
Any alternative to Behmor?
True, but the alternatives that can roast a full pound have so much better control over the roast with telemetry that it ends up being a worthwhile upgrade for most
- 9 minutes ago
- Forum: Blog
- Replies: 52
- Views: 3020
Mazzer Philos Comments
The video in the last entry shows how the grind adjustment works. There is a lock at the zero marking (as well as the 145 marking), so it is impossible to make more than one turn on the adjustment wheel. I removed the collar to check for the chirp, and it was approximately at -3. After I changed
- 12 minutes ago
- Forum: Grinders
- Replies: 31
- Views: 2397
Turin DF83 V2 Drifting Zero
Do DF64v's have this problem?
- 13 minutes ago
- Forum: Lever Espresso Machines
- Replies: 4
- Views: 79
1959 Faema Urania Three Group Hydraulic with Hotel Group
Are you sure about that? Looking closely at the plumbing, it looks to me like you have a line pressure inlet fitting at the front of the drip tray surround that feeds a manifold that wraps around the back side of the frame to feed the groups and the valve with a lever on it. Given the other valve
- 21 minutes ago
- Forum: Coffee Brewing
- Replies: 53
- Views: 2971
Fellow Aiden anyone?
And the same could be said of a pourover cone for a lot less money
- 30 minutes ago
- Forum: Grinders
- Replies: 11
- Views: 510
Shot inconsistencies with SSP Cast LS
No I haven't tried
- 1 hour ago
- Forum: Coffee Brewing
- Replies: 53
- Views: 2971
Fellow Aiden anyone?
I'd have to think the main advantage is the brewing temps for certain roasts give it the slight edge over a steady temp with the moccamaster if going off of my experience with an espresso machine but I'm not a next level coffee guy so who knows
- 1 hour ago
- Forum: Coffee Brewing
- Replies: 53
- Views: 2971
Fellow Aiden anyone?
Don't take this the wrong way but that's saying a lot without saying anything at all
- 1 hour ago
- Forum: Grinders
- Replies: 1
- Views: 116
Sculptor 078 & Ode SSP - keep both?
you could always keep it and try the difference or slap different burrs in the Ode. I'm curious if the 078 versus SSP MP 64MM still holds up