Recent posts
- 20 minutes ago
- Forum: Coffee Brewing
- Replies: 55
- Views: 3028
Fellow Aiden anyone?
It's rather big advantage that it bloom for as much as you like, for as long as you like... It's the same with an espresso machine that can profile over one that isn't able to. Moccamaster only works with a rather fixed volume that isn't particularly precise, and the way it works means it is very restricted on grind
- 21 minutes ago
- Forum: Repairs, Restorations & Mods
- Replies: 0
- Views: 2
2019 Gaggia Classic Pro, Indicator Light Issue
I recently purchased (in New Zealand) a second hand GCP for my sister, it was very cheap but not without problems! Someone had stripped the screw holding the shower screen in place, which in the end was relatively simple to remove. The main issue though is that the ON OFF indicator light only partially worked when I received
- 39 minutes ago
- Forum: Grinders
- Replies: 280
- Views: 26915
The new DF83v
I have not personally had previous experience with df64coffee.com but I do know someone who has ordered 7 or 8 griddners from them previously (as well as burrs) and have not had issues (ie they always fulfil orders, and I'm told they do a good job aligning them as they are NOT pre-aligned from the factory). I believe they
- 1 hour ago
- Forum: Blog
- Replies: 54
- Views: 3113
Mazzer Philos Comments
What does hyperaligned mean and how is it measured? Does this concern machining tolerances or mounted burr runout measured by deflection gauge? I am quite confused by the idea that only small, boutique manufacturers can produce well aligned grinders. Perhaps big manufacturers haven't focused on it, but I'd bet that they're the ones that can scale up production
- 1 hour ago
- Forum: Grinders
- Replies: 3
- Views: 170
Sculptor 078 & Ode SSP - keep both?
I agree, I have both out side by side on the bench right now and I struggle to find a reason to use the ode over the 078
- 1 hour ago
- Forum: Repairs, Restorations & Mods
- Replies: 0
- Views: 6
Bypass dose timer of Eureka Mignon MK2
I want to know if there is a way to connect the solder points left behind after the timer/dose dial fell off. (I don't use it anyway) It became detached after mounting screw fell out that held it to the circuit board. I would appreciate any advice. Fanks
- 1 hour ago
- Forum: Blog
- Replies: 54
- Views: 3113
Mazzer Philos Comments
Thank you for your explanation but I was just wondering if I need to calibrate it to zero before I start using the grinder If it's factory calibrated I don't hv to, I'm a bit OCD, I must complete this procedure before using
- 1 hour ago
- Forum: Repairs, Restorations & Mods
- Replies: 3
- Views: 69
Help with brew pressure on izzo espresso machine
Is it possible to get one of you, to show it on a diagram of the machine? Which it's about
- 3 hours ago
- Forum: Buying Advice
- Replies: 1
- Views: 70
Help purchasing ECM Home, Profitec Go, or Pro 300...
I recommend the Profitec drive, it has the auto on function, so you don't hv to wait for the heat up time
- 4 hours ago
- Forum: Buying Advice
- Replies: 4
- Views: 170
Reliable German shop online...
Thanks!