YES! No video is too basic. And anyone watching who thinks it is gets to feel superior, so everyone is happy! (I was a math professor for a decade and believed that every time someone asked a question, ten other people had the same question but were afraid to admit it.)

A typical finding when researching greases for use with o-rings and seals: {link} There is an elastomer compatibility chart on page 7. It seems to me, a PFPE based grease is the best choice material for use on our espresso machines with silicone piston seals. Its operating temperatures far exceed our use, safe with silicone and

Titus with 49mm CT2 and sworks adapter. Basically get him to make an adapter for the Cremina as well {image} {image}

How bad is your reservoir? I have an extra one that seeps a little through some cracks and has a dribble through the working filter and valve. The cracks are visible and radiate from the mounting holes for the valve and electrical tab. Perhaps the cracks could be repaired with some sort of coating, but the reservoir does

I used a Ceado E37J for a couple years. The stock 64mm burrs ground a good extraction. Better than the Macap M4 it replaced. SSP HU burrs I tried out didn't work well with it. Didn't fit well and gummed up regularly. The slide grind adjustment was really stiff. I think it had to

Hello, I was wondering what the best practice is for using a Versalab/Hedone style portafilter holder with smaller than 58mm portafilters. I have Hedone Honne and new Cremina on the way, so I'm thinking there must be more people in similar situation?

can i recommend: lighter roast 92/98 5s infusion at 2 bar remove the cup at 17gin/43g out med/dark 90/96 infusion 5s at 2 bars remove cup at 17g in 34g out after that there really isnt much you need to do, the evo extracts great,so anything you know of any non evo lever, dont

As John says, this Haynes Lubri-Film Plus is a petroleum (mineral oil) based lubricant. It likely is safe for use on the Flair silicone seals, but won't last due to becoming very thin at the high operating temperatures. As John says, it is not safe for use on black rubber, EPDM, Butyl or Buna orings or seals.

Just to add - basic videos on operation and maintenance would be greatly appreciated Dave, no matter how basic

Are you thinking $389?