I make my concentrates with baking soda and Epsom salt in RO/DI water. I mix into on-liter bottles and then pour out what I need when I make my one-liter batches of mixed water. My notes say 1.68 g/kg -- Sodium bicarbonate -- NaHCO₃ 2.46 g/kg -- Epsom salts -- MgSO₄*7H₂O Weighing out to 10 mg is

Thank you!

Thank you so much! Unfortunately that piece is missing too, but the Breville website DOES have an outer burr replacement...without the groove!

If you have the machine running 24/7 you might run into issues with the electronics in the PID controller getting sad above the group head. I've had a couple iterations on install locations . . . once below the drip tray (that became problematic with moisture), once in the face like you have where I had to install a

The current factory spec as per the parts manual is 12 bar. Note that - and I realize that this is semantics because the physical valve is the same - the valve on the Strega is an suppression/expansion valve, not an over-pressure valve. The difference is in purpose - the valve in the Strega is located to protect the

Theres a few tips out there which helped our roasting experience. Don't micro manage the roast. Good beans know what to do. Give em' enough heat and your on your way. Every roasting machine has a sweet spot. Find it and don't make it do what it doesn't want to. Use your eyes, ears and nose to

Does your outer burr have the groove in like this one: {link} if so then i believe you have the newer baratza 6 pointed inner burr

Hi All - I recently purchased a Bezzera Strega TOP, which I am so far loving. I wanted to check the PI and brew pressure and to see how they ramp and decline. I also wanted to verify what pressure the OPV is actually set to. The dealer told me 15 bar, while I've read 11bar elsewhere

I really like this machine. Fast heating and simplicity is important for me. I have a flair 58 and i am happy with it but i miss milk drinks as i dont like solutions such as bellman and subminimal. This offers also steaming capabilty and it definitely suits to my needs combining with the flair for longer ratio shots where

Just wanted to say thanks to @Jaroslav for all the work here. For any other UK based people who are interested in this modification, I've been able to source both the Sorbothane Stud Mounts and Washers from gelmec.co.uk. They have a minimum order of £25 and shipping is quite expensive so all in all it cost me £36.11+vat for 2