Recent posts
- 14 minutes ago
- Forum: Espresso Machines
- Replies: 1655
- Views: 166527
La Marzocco Linea Micra
We debated the yellow. But red won out
- 20 minutes ago
- Forum: Lever Espresso Machines
- Replies: 3
- Views: 95
Switching between Flair 58 and Robot - grind size?
I have both. It really depends on what basket you're using with the Flair. Their 'low flow' basket use a similar grind to the Robot (if you use the same dose). For straight-walled baskets you'll usually need a tighter grind with the Flair - but if you want you can just lower the dose for the Robot instead of
- 21 minutes ago
- Forum: Tips and Techniques
- Replies: 5
- Views: 65
7g VST/LM Single Shot Basket Tips
Ah, so it's supposed to be soggy? This makes sense as I don't know what else I could do! Also changed my output to 16g, thanks for weighing in
- 23 minutes ago
- Forum: Tips and Techniques
- Replies: 5
- Views: 65
7g VST/LM Single Shot Basket Tips
Copy that. I am having fun! I adjusted my weight to 16g this morning based on your encouragement. Took about 5-7s for the first drops then a nice stream by 15s if I remember and done by 25s. Tasted great but I'll watch the stream closer. I was focused on the fact someone in my family took the last of
- 24 minutes ago
- Forum: Lever Espresso Machines
- Replies: 15
- Views: 389
Olympia Cremina lever questions after group gasket replacement
Good morning! After another almost perfect pull with my Cremina, I felt the need to muse about your problems. First, you're in Washington State? Could you locate someone who owns a Cremina for a demonstration of proper technique. When I started I was tutored by a couple of HBers in the Chicago are to get that special touch for
- 47 minutes ago
- Forum: Lever Espresso Machines
- Replies: 3
- Views: 95
Switching between Flair 58 and Robot - grind size?
They are going to be very similar but it is easier to pull a higher pressure shot on the flare so if you are typically doing higher like over 9 bar shots they may run slightly different as I would typically run my robot shots 7 or 8 bar well on the f-58 more often I would do 9bar
- 3 hours ago
- Forum: Espresso Machines
- Replies: 1655
- Views: 166527
La Marzocco Linea Micra
My LM quite often seems to turn off at what I assume is the "power saving" timeout despite me either being mid-use or just after I have finished. Is this intended behaviour? I assumed that if I interacted with the machine at all it would reset that timeout
- 4 hours ago
- Forum: Espresso Machines
- Replies: 5
- Views: 168
Espresso shot - coffee appears immediately - problem?
Personally I pay no attention to having to reach a certain time, volume or yield. No form of measurement will trump taste/texture and with espresso the variables are really constantly changing, so don't overthink it
- 4 hours ago
- Forum: Espresso Machines
- Replies: 258
- Views: 20171
La Marzocco releases Brew by Weight for Linea Mini
Does someone else here has a lot of connectivity problems with the La Marzocco Lunar scale? Every 2-3 days when I put my Linea Mini out of stand by modus (with the app) the scale will not connect anymore with my machine. To connect the scale again it's also trial and error. Sometimes it's helping to shut down my
- 4 hours ago
- Forum: Espresso Machines
- Replies: 5
- Views: 168
Espresso shot - coffee appears immediately - problem?
But if I simply adjust the grind finer, I will end up with too little yield at the end (my quantity is ok 18g in, 36g out, in 30 seconds). So therefore I am guessing I need to probably try grinding finer and also putting less than 18g in the portafilter. I will have a play today and see the