NEW - Orphan Espresso silicone gasket set for Olympia Cremina - Page 2
- naked-portafilter (original poster)
- Posts: 698
- Joined: 10 years ago
I made two short videos during todays roasting :Tonefish wrote:Thanks Gabor! So that fit snuggly? I see that my last OE ones were viton, so this could be different/better.
-
- Posts: 1401
- Joined: 7 years ago
Very NIce Gabor! I could see that the leading edge of the bottom seal and the trailing edge of the top seal stick out past the piston which was not the case with the triton ones I recently purchased. This looks good. Thanks for the video post!naked-portfilter wrote:I made two short videos during todays roasting :
LMWDP #581 .......... May your roasts, grinds, and pulls be the best!
-
- Posts: 497
- Joined: 12 years ago
So what was the "sleeve" you put around the piston seals to compress them and make installation easy? Is that a custom piece?
- drgary
- Team HB
- Posts: 14392
- Joined: 14 years ago
naked-portfilter wrote:Inserting the piston with that sleeve is an easy play and no stress at all for the gaskets. It's delivered with the piston pressure kit.
Gary
LMWDP#308
What I WOULD do for a good cup of coffee!
LMWDP#308
What I WOULD do for a good cup of coffee!
- naked-portafilter (original poster)
- Posts: 698
- Joined: 10 years ago
We machined the sleeves for the piston pressure kits only (Pavoni and Cremina). I will order an extra batch of them and sell separately also.
-
- Supporter ♡
- Posts: 852
- Joined: 7 years ago
Thanks Gábor!naked-portfilter wrote:We machined the sleeves for the piston pressure kits only (Pavoni and Cremina). I will order an extra batch of them and sell separately also.
Rocky
-
- Posts: 497
- Joined: 12 years ago
Excellent, thanks!naked-portfilter wrote:We machined the sleeves for the piston pressure kits only (Pavoni and Cremina). I will order an extra batch of them and sell separately also.
-
- Posts: 1401
- Joined: 7 years ago
Awesome Gabor!naked-portfilter wrote:We machined the sleeves for the piston pressure kits only (Pavoni and Cremina). I will order an extra batch of them and sell separately also.
LMWDP #581 .......... May your roasts, grinds, and pulls be the best!
- mrak
- Posts: 24
- Joined: 7 years ago
I wonder if there any news about Cremina silicone gaskets? When and where they will be available?