Smaller screw for Rancilio Silvia dispersion screen - Page 2
- rsinger
- Posts: 54
- Joined: 15 years ago
Finding the screw is the easy part. You can find the stainless steel flat allen-head English 10-32 1/2" screw like that shown in the photo of my mod at LOWES
What I was saying is that as far as I know, no retailer sells the counter sunk dispersion screen or counter sunk support for it.
Rick
What I was saying is that as far as I know, no retailer sells the counter sunk dispersion screen or counter sunk support for it.
Rick
Rick Singer
-
- Posts: 23
- Joined: 13 years ago
-
- Posts: 33
- Joined: 14 years ago
I would not use chrome-plated steel for the dispersion screen screw. After a few times taking it apart, the chrome will get scratched/weakened, and rust will start forming. Descaling the boiler will also etch the chrome plating, very likely
Stainless steel is the only acceptable material for that screw (or brass, but I doubt you can find a brass screw that easily)
Stainless steel is the only acceptable material for that screw (or brass, but I doubt you can find a brass screw that easily)
-
- Posts: 221
- Joined: 13 years ago
Has anyone else had major problems with dispersion of water after doing this mod? I have the jet coming out fine except there is usually a hard stream coming out on one side. I'm not sure if I just didn't do it straight or if it's something with the stream.