Below is a collection of this forum's most popular topics. To nominate a thread for inclusion in this list, please post a reply to this message. Remember to check the Resources page for other references.
Seem like Mahlkonig finally reinvented the EK43, with some major upgrades.
BLDC motor, spotlights, grind adjustments electronically and in um intervals a lovechild of Mazzer ZM and EK43, seem like tool free access to burr, touch screen.
Can you post a picture of your filled baskets please? I have seen a few videos and it doesn't seem to be perfectly distributed ready for tamping? I have seen a teardown and there is apparently a wiper inside the bottom cone to free off any attached grinds. I was wondering if a...
I've been experimenting with restricting the rate of beans flowing into the 64mm burrs of the DF64.
Why??
Originally intended to reduce the propensity for extra-fine grind settings to pile up in the burrs and choke the flow. I've also observed grinder 'reflux', where...
About 5 years ago I began getting into specialty coffee and my journey began with the bean. I used a chemex and bought a Breville smart grinder; pretty straight forward. I know about reddit and began to read about coffee - as a hobby. And, eventually, I found this forum where I...
Keen to hear people experience with 80mm burrs. While there's not as many options as 98mm or 64mm, there are still a few out there and it would be great to have an area where these experiences and knowledge of the burrs can be shared.
A while back my grinder started to take forever to grind the desired coffee. For example on grind size 39 it takes 75 seconds to grind 60 grams of coffee. Before the issue I think it took little less than 50 seconds. I replaced the top and bottom burrs per Breville's suggestion...