espro.ca: make every coffee remarkable

Missing Mazzer burr springs

Postby Erich4130 on Thu Sep 29, 2011 3:36 pm

Hi-
Just picked up a Mazzer Mini in very good condition but the springs (3) that support the upper burr are missing.
Anyone know a good source or can someone post the dimensions and image of these springs?
Thanks, Erich
Erich4130
 
Posts: 2
Joined: Sep 29, 2011
Location: Milwaukee, WI

Postby HB on Thu Sep 29, 2011 4:36 pm

Espresso Parts has them here; I found it by searching their site using this exploded diagram. The part is labeled MAZ50 in the diagram. Below are photos of the springs in question:

Image Image
From Mazzer Mini Component Photos

They're probably missing because someone turned over the grinder to dump out the grounds and forgot the springs will fall out into the trash (don't ask how I know).
Dan Kehn
User avatar
HB
 
Posts: 14238
Joined: Apr 29, 2005
Location: Cary, NC
Quotable Quote
"You should be able to grind, dose, distribute and tamp in under 45 seconds, one minute tops. If you can't, you've accumulated too many barnacles on your prep ritual." --Jim Schulman, Review this espresso extraction/morning routine please


Postby allon on Thu Sep 29, 2011 9:00 pm

HB wrote:They're probably missing because someone turned over the grinder to dump out the grounds and forgot the springs will fall out into the trash (don't ask how I know).


Shop vac.
LMWDP #331
User avatar
allon
 
Posts: 1623
Joined: Apr 23, 2011
Location: Northern VA

Postby Erich4130 on Thu Sep 29, 2011 11:08 pm

Thanks!
Erich4130
 
Posts: 2
Joined: Sep 29, 2011
Location: Milwaukee, WI