New La Pavoni PPG-16 question
-
- Posts: 5
- Joined: 8 years ago
Just started practicing with my new machine and had a question about the amount of water coming through the steam wand. In 15 seconds I measured almost 1/4 cup of water. Seems awfully excessive. Is the pressure too low? It was as warmed up as possible, after about 30 minutes. Pressure won't go above 0.8 bar, though.
- redbone
- Posts: 3564
- Joined: 12 years ago
You should be getting mostly steam and not water as found in a hot water nozzle. If it's a new machine I would inquire with your place of purchase as to your issue. Does this have a single on button or a dual button low\high ? Can you measure the temperature of the water coming out of the nozzle ?
Between order and chaos there is espresso.
Semper discens.
Rob
LMWDP #549
Semper discens.
Rob
LMWDP #549
-
- Posts: 5
- Joined: 8 years ago
Single On button. I'll try to get some temp measurements tonight
-
- Posts: 5
- Joined: 8 years ago
Temperature reading was about 150 degrees F. Not much water this time, but I hadn't pulled a shot prior to this test, as before
-
- Posts: 164
- Joined: 10 years ago
1/4c in 15s sounds like a lot. Are you filling the boiler past the sight glass?
- redbone
- Posts: 3564
- Joined: 12 years ago
Good point Scott. Sometimes the simplest things are easiest to overlook.
That water should be in the mid 180's F from my experience.
That water should be in the mid 180's F from my experience.
Between order and chaos there is espresso.
Semper discens.
Rob
LMWDP #549
Semper discens.
Rob
LMWDP #549
-
- Posts: 5
- Joined: 8 years ago
Thanks, i probably overfilled, because it hasn't happened again